Carpet Stretching Auckland
A carpet loses some of its tension & solidity as it ages. In the event, if we don’t do the carpet restretch soon, the pile seated higher will degrade prematurely. OSH NZ has been cracking down on these loose carpet concerns as a consequence of accident hazards carpet humps can present. Steam ‘n’ Dry Carpet Repairs Auckland based in South Auckland, North Shore, East, West Auckland since 1987, are able to carpet restretch back into good shape, trimming off any excess.
All carpet manufacturers, as well as the Carpet & Rug Institute (CRI), advise that all new carpets be “power stretched” at the time of carpet installation. The significance of carpet restretches and power stretching your carpets.
The majority of carpet installers are paid up by the meter. Usually, they don’t take the necessary time to utilize the power carpet stretching Auckland method. In most cases, when don’t install with a power carpet stretch. New carpets will start to ripple and wave in about 16 months.
However, when Auckland carpet stretching is carried out by our Carpet Repairs Auckland, you’ll certainly have your carpet to look good. Indeed clean and last longer.
How to DIY Restretch Carpets
Instructions Things You’ll Need:
- Carpet cutter or utility knife
- Power carpet stretcher unit
- Knee kicker
Prepare the Smoothedge Tack Strip
- Pull the carpet away from one corner using pliers until you can get a good grip with your hands. Continue to pull the carpet away from the tack fix strip, being careful to keep seams intact, especially around doorways. Since you are restretching an existing carpet, you will leave the tack fix strip along one full wall and pull up the other three sides.
- Use pliers to remove the staples from the underlay then pull it back. If you don’t remove the staples first, the underlay may rip because most of it is made of a foam type of material.
- Remove the old tack strips, using the pry bar. The tacks are extremely sharp so a pair of work gloves is a good idea to use here.
Lay the new tack fix strip in place with the tacks pointing towards the wall and secure them to the floor with nails driven into the pre-set holes. Place the strips without gaps between them, especially at the corners.
Note: Staple the underlay back in place. Use a staple every 3 inches and along seams. Stretch the Carpet.
- Rent a power carpet stretcher and knee kicker if you don’t own them. It’s probably a good idea to ask a friend to help at this point. If you have never used a power carpet stretcher, have someone at the rental company give you a rundown on how it works.
- Sometimes it’s just better to call the experts such as Steam ‘n’ Dry Carpet Repairs Auckland offers expert carpet repairers, laying, flood fix, stain removal, carpet cleaning, drying repair in North Shore, West, East & South Auckland
- Start power stretching carpet, beginning at the center of the wall that has the carpet that you left attached to the tack strip. Carpet stretch a section then move over 18 inches and stretch another section, each time pulling the carpet and hooking it onto the tack strip. Continue in this manner, first working your way towards the side of the room that has a door. Then repeat on the other side, starting in the middle and working your way out as before.
- Phone the professionals Steam ‘n’ Dry carpet repair & laying service, in West Auckland, North Shore, Hibiscus Coast, East, South Auckland Since 1988 on 0800 783-266.
Carpet Stretch Tips
- Carpet stretching the sides. This time you only need to start about a foot away from where you pulled back the carpet. Stretch and hook the carpet onto the tack board in the same manner as before and then stretch and secure the other side.
- Use the knee kicker in areas that are hard to get to, such as corners and around built-in cabinets. Sink the teeth into the carpet about 6 inches from the wall and use your knee to push the tool and stretching carpet towards the tack strip. Grip the edge of the carpet and pull it onto the tacks as before.
- Run the carpet cutter along the baseboards and cut the carpet side, leaving the backing intact. Use the utility knife to trim around corners and built-ins, then cut the backing and leave about 20mm carpet overhang to tuck under the baseboards.
- Finish your carpet stretching Aucklandjob by pushing the edge of the carpet fix into the tack strip and under the baseboards. A screwdriver and hammer will do the job, but a quicker way is to use the carpet cutter. You won’t be cutting the carpet, just forcing the front edge of the carpet cutter into the carpet and dragging it along the wall. This will mash the carpet into the fix tack strip and force it underneath the baseboards in one movement. Call the experts such as Steam ‘n’ Dry Carpet Repairs Auckland.
For over 3 decades Steam ‘n’ Dry Carpet Stetching Auckland is based in South Auckland, North Shore, East, West Auckland. Phone the professionals Steam ‘n’ Dry carpet repair & laying service. Since 1988 on 0800 783-266.